WPC Door Factory Introduces The Installation Details Of WPC ：

①Besides the door, the door cover is required to be installed horizontally and vertically; there is no gap at the connection.

②The size of the door gap should be 2-3mm on the top, 6-8mm on the bottom, 2-5mm on the hinge side, and 3-4mm on the door lock side; the gap should be uniform.

③The vertical angle line is 1cm higher than the horizontal right angle line.

④After locking the door, there is no gap or shaking between the door and the cover.

⑤The two vertical sleeves must be installed horizontally, and there must be no "eight" characters or uneven lower ends.

⑥There should be no fan phenomenon.

Through the above introduction,WPC bathroom doors manufacturer hopes that you can simply refer to the content of this article in future use.

www.wpcdoorwallboard.com